GI Cable Tray

GI Cable Tray Manufacturer

GI cable tray manufacturer

Product Description

In the electrical wiring of buildings, a GI Cable Tray system is used to support insulated electrical cables used for power distribution, control, and communication. GI Cable Tray Manufacturer is used as an alternative to open wiring or electrical conduit systems, and is commonly used for cable management in commercial and industrial construction. They are especially useful in situations where changes to a wiring system are anticipated. We are engaged in offering Galvanized Iron Perforated Cable Tray.

Counted as first among the best, we are engaged in offering the best quality of GI Perforated Cable Tray. The offered products are used storage of different materials in warehouses and storage units.

Material Used:

Common GI Cable Trays are made of galvanized steel, stainless steel or aluminum. The material for a given application is chosen based on where it will be used. Galvanized tray may be made of pre-galvanized steel sheet fabricated into tray, or may be hot-dip galvanized after fabrication. 

We are leading manufacturer and trader of GI Cable Tray and our product are made up of good quality.

 

Instructions:-

 

  • Material: Hot Dip Galvanized
  • Length: 2.5 mtrs – 3 mtrs
  • Width: 100 mm – 1100 mm

 

Applications:

  • Housing apartments
  • Suitable for commercial complexes

Features:

  • High load carrying capacity
  • Robust construction
  • Corrosion resistance finish
  • Enhanced functional life

 

GI Cable Trays are used as support for laying Power or LT Cables. Two types of GI Cable trays are in frequent use:

1. Ladder Type Cable Trays
2. Perforated Cable Trays

Ladder Type Cable Trays:

Generally used in applications with intermediate to long support spans 12 to 30 feet.A ladder cable tray without covers permits the maximum free flow of air across the cables. This allows the heat produced in the cable’s conductors to effectively dissipate. Under such conditions, the conductor insulation in the cables of a properly designed cable tray wiring system will not exceed its maximum operating temperature.

The rungs of the ladder cable trays provide convenient anchors for tying down the cables in the non-horizontal cable tray runs or where the positions of the cables must be maintained in the horizontal cable tray runs. This capability is a must for single conductor cable installations. Under fault conditions (short circuit), the magnetic forces produced by the fault current will force the single conductor cables from the cable tray if they are not securely anchored to the cable tray.
Cables may exit or enter the ladder cable trays through the top or the bottom of the cable tray. Where the cables enter or exit conduit, the conduit to cable tray clamps may be installed upright or inverted to terminate conduits on the top or bottom of the cable tray side rail.
The most common rung spacing for ladder cable tray is 9 inches. This spacing may be used to support all sizes of cables.

Perforated Cable Trays:

These are the most common t
ype of cable trays available in market. GI perforated Cable Trays in GP is common whereas the other type, in Hot Dip Galvanised or Powder Coated Cable trays are supplied against order only.

The follwoing are common sizes
1.6 mm thickness – 50X40 mm
1.6 mm thickness – 100X40 mm
1.6 mm thickness – 150X40 mm
1.6 mm thickness – 200X50 mm
1.6 mm thickness – 250X50 mm
1.6 mm thickness – 300X40 mm